Anzeige
Erschienen in:
28.11.2022 | Original Article
Comparative assessment of frictional forces between differently designed esthetic brackets during simulated canine retraction
Erschienen in: Journal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie | Sonderheft 3/2023
Einloggen, um Zugang zu erhaltenAbstract
Objectives
To evaluate force loss due to friction (FR) with an emphasis on esthetic brackets and their design differences during simulated canine retraction.
Materials and methods
The tested brackets were round and sharp-cornered conventional-ligating brackets and round-cornered self-ligating brackets. The tested archwires were stainless steel (0.018 × 0.025″ and 0.019 × 0.025″, and 0.018″) archwires. A total of 90 bracket–archwire combinations in 9 equally-sized groups (n = 10) were analyzed. Canine retraction was experimentally simulated in a biomechanical set-up utilizing the custom-made orthodontic measurement and simulation system (OMSS) using a NiTi coil spring that delivered a constant force of 1 N. The simulated retraction path was up to 4 mm. FR was compared among groups using the Welch t‑test. Significance level (α) was set to 0.05.
Results
The round-cornered conventional-ligating bracket exhibited the least FR (28.6 ± 5.4%), while there were no significant differences in FR between the round-cornered conventional-ligating bracket and the round-cornered self-ligating bracket with 0.018″ stainless steel wires. However, the round-cornered self-ligating bracket exhibited the least FR (34.9 ± 5.1% and 39.3 ± 4.6%) with 0.018 × 0.025″ and 0.019 × 0.025″ stainless steel archwires, respectively. The sharp-cornered conventional-ligating bracket showed the highest FR of 72.4 ± 3.0% among the bracket systems tested in this study.
Conclusions
The round-cornered conventional-ligating bracket showed less FR when compared to sharp-cornered conventional-ligating bracket. Conversely, the round-cornered conventional-ligating bracket exhibited greater FR when compared to the round-cornered self-ligating bracket, with an exception with respect to the 0.018″ wire. In general, FR increased with increased wire dimension.